4000psi Turbo Head 090
Our price: $65.00
QRA Ultimate HEAVY DUTY Turbo Head 4000psi 090
Suits 20hp+ High Pressure Washers @ approx 30 - 36 L/Min
If you are replacing an exising Turbo Head - Check the size stamped at the base of the Turbo Head.
Comes with 1/4" Quick Connect Fitting Or Just Direct Fix To Lance
Extra Heavy Duty / Longer Lasting / Generates better Cutting & Cleaning Power
Turbo nozzles are one of the most important high pressure cleaning accessories developed. The circular motion also adds extra agitation to cleaning tough jobs like caked-on mud, stubborn in-ground stains, graffiti etc.
They are designed to provide a 200% cleaning efficiency over normal nozzles.
The precision ceramic orifice and matching seat, along with the high strength forged brass housing; provide a long life accessory without other moving parts.
Snaps easily into your lance & with its Solid Brass Construction and a Heavy Duty Solid Rubber Casing.
The rotating ceramic tip cuts through the most built up dirt & grime with ease! Turns paved areas back looking like new!!
USING TURBO HEADS
When pulling Gun Trigger, ALWAYS have Turbo Head POINTING DOWN to Start !
This avoids the Rotating Core from being shot forward & compressing the ceramic tip back into the body of the core.
If the orifice of your Turbo Head Core is laying below the opening at the outlet end - then this is the reason your Turbo Head is NOT working properly anymore.
If the orifice in the core is still lining up with the outlet opening and not working properly - there could be debris in it.
TO CLEAN OR REPLACE CORE
1. Remove rubber shroud
2. Hold a spanner each end and undo rear end of brass body.
3. Tip out core and remove outlet from tapered end. (Should push into body of the Turbo Head)
4. Replace with new core by holding the Turbo Head tapered end down and drop the new core in. (Making sure the ceramic tip is located into the seat of the outlet).
5. Whilst still vertical - screw back on rear section of the Turbo Head Body.