B.A.R. Group
&   BE
Fast Delivery Pressure Washers
Phone us
Follow us on Facebook Follow us on Youtube
menu button iconMenu

Your Cart

0 Item(s), $0.00

View cart >


Click for Current Specials



  • Stay in touch with new products, latest arrival, and special offers.

    Subscribe now >
Select your Currency:
Items in Trolley: 0 (AUD 0)
Adjustable Bypass Unloader Kit

Adjustable Bypass Unloader Kit

Adjustable Bypass Unloader Kit

RRP: $276.00
Our price: $165.00

Freight calculator


Qty: Add to trolley >  Buy now >
Important Pre-Start & Care Instructions1. Remove the top Banjo Bolt (High Pressure) & bottom Banjo Bolt from the pump manifold & remove the side assembly.
2. Install ¾” Inlet Fitting directly in place of bottom Banjo Bolt into manifold
3. Install bypass unloader assembly into top high pressure outlet with the 3/8” screw connection banjo bolt
4. Remove brass inlet ½” plug on lower section on opposite side of pump manifold & replace with ½” hose barb fitting (Use Teflon tape).
5. Connect unloader hose to hose barbs & tighten up hose claps.
Hose can be as picture above or run over frame.

Adjustable Bypass Unloader Kit

Please Specify What Hose Connection Fitting You Require ie: 22mm Screw Connect or 3/8" Quick Connect.

Our Bypass Unloader Kit allows you to run your Pressure Washer longer - after you have let go of the gun trigger.

Water will now continue to circulate via the Bypass Unloader thru 3 metres of 1/2" Bypass Hose & back into the inlet side of your pump.

Because water is now flowing thru the pump manifold & out thru the unloader then back into the inlet - this significantly reduces head build up.

A large percentage of pressure washers have a Pressure Activated Unloader Assembly bolted to the side of the pump manifold. This allows water to circulate in the manifold only - creating rapid heat build up. To avoid this heat build up you have to either turn down or switch off the pressure washer after releasing the gun trigger.

This can be easily replaced with our Bypass Unloader Kit.

The bypass hose can either be curled up (as pictured) or run anywhere around the pressure washer frame.

Only suits Crank Shaft Pumps / Gear Box Pumps.

Comes with:

* Hose Connection Fitting Of Your Choice

* 3/8" Unloader Connection to Pump Manifold

* 2.8M x 1/2" Spiral Wire Inserted Clear Cooling Hose

* 1/2" Bypass Hose Barb Connection to Inlet Side of Pump

* 1/2" - 3/4" Garden Hose Fitting

* 2 x Hose Clamps

Over 35 Years