Check Valves 2400psi KH 15.08 Heavy Duty Crank Shaft Pump

Check Valves 2400psi KH 15.08 Heavy Duty Crank Shaft Pump 

On a triplex Pump there are six (6) check Valves.

3 Inlet Valves on the lower side & 3 Outlet Valves on the upper side.

These Check Valves are fitting into the manifold onto the 'O' Ring Seal, and are easy to install.

Check Valve Outer Diameter -  15.91mm

Check Valve Height               -  15.14mm

Heat build up can deform the Check Valve Housing, consequently you will suffer a huge decrease in pressure.

A good idea if you don't have one already, is to install a Thermal Relief Valve (Dump Valve).  This will assist in protecting the Check Valves by releasing over-heated water and allowing fresh water in.

Alternatively - Do NOT leave your hand off the gun trigger while machine is running for more than 90 seconds.